918-KOB automatic industrial wire stripping machine :

This machine suitable for copper wire, single core wire ,multi core
wire,aluminum wire,sheet cable wire. Wire stripping range:
1-42mm. This machine is practicable and easy to handle.

operation:

Push the Switch up to turn the Motor ON, Check whether the
machine work well. Make sure there are no people on the output
side of the machine. Comparing the cables/wires diameters with
the feeding holes on the machine, feeding the cables/wires one
piece at one time.
1,Before feeding the cables/wires, please cut off the head of
the cables/wires, to avoid gaps caused to the blades.
On the output side, if the cuts on the cables/wires are too
deep, please check below points:
1: Please adjust the handles on the input side, screw
down or loose them. (M12 handles)
2; Check whether the cables/wires on the right position as
you feeding them.
3Make sure the blades are sharp, if not, polish them
with the oil stone
2,On the output side, if see the plastic (PVC) has been
stripped, but the copper wires can not been disgorged, please
check below 4 points:
1Polish the axis of the upper side shaft with the oil stone
properly
2Check whether the springs are loose, if yes, screw
down to make them tighten
3The diameter of the cables/wires are too small, please
adjust the space between the two axis to 0.3-0.6mm.
4If the cables/wires you want to strip are hot, also can
not get the copper wires stripped out.
3,If the cables/wires were blocked in the axis, please check
below points:
1Check if the V-belts are loose.
If the springs on the press wheels are too tight, loose them.
2There are too much oil on the cables/wires, please wipe
it(make sure the machine is turned off when you wipe the axis)
4,If see the blades tilted:
1Check whether the center adjuster was loosed.
2Centering adjustment and adjust the screws of two sides of it.